Server - Properties tab - Security Center 5.8

Security Center Administrator Guide 5.8

series
Security Center 5.8
revised_modified
2020-08-17

On the server Properties tab, you can view the network settings configured for this server in Server Admin.

NOTE: All network settings are read-only in Config Tool. They must be configured in Server Admin.
Public address
Public address of this server. This setting appears only if a public address is configured in Server Admin.
Port
Port used by the Genetec™ Server service to listen to commands received from other Security Center servers on the public address.
Proxy
This switch is turned on if this server is configured as a proxy server for a private network protected by a firewall.
Private addresses
List of private IP addresses used for the communication between Security Center servers. Only the private addresses enabled in Server Admin appear in this list.
Port
Port used by the Genetec™ Server service to listen to commands received from other Security Center servers on the private addresses.
IMPORTANT: If the server is running in backward compatibility mode (5.2 or earlier), the first address in the private address list must match the IPv4 properties of the network entity the server belongs to in the Network view task.

Secure communication
Use this section to view the current identity certificate used by the server to communicate with other Security Center servers.
Issued to
Subject of the current certificate. A self-signed certificate created at software installation appears in the form GenetecServer-{MachineName}.
Issued by
Name of the certificate authority (CA) that issued the certificate. The issuer and the subject are the same for self-signed certificates.
Valid from/Expiration
Validity period of the current certificate.

Click View to open the dialog box to view more information.