Aligning the SharpX with the target - SharpX X1S, X2S, X1S-CN, X2S-CN, XSU

AutoVu Hardware Guide for SharpX Mobile Installation

Applies to
SharpX X1S, X2S, X1S-CN, X2S-CN, XSU
Last updated
2018-10-05
Content type
Guides
Guides > Installation guides
Language
English (United States)
Product
SharpX

After you set up and properly position the tripod, use the live feed in the Sharp Portal (advanced mode) to align the camera with the target.

What you should know

If the system includes an X2S/X2SU LPR Processing Unit, you will need to open a separate Sharp Portal for each of the SBCs.

Procedure

  1. Log on to the Sharp Portal.
    After entering the password and selecting your language, press Ctrl + Enter to log on in Advanced mode, which gives you access to additional settings not found in regular mode.
  2. In the Live Feed tab, select the LPR Camera feed in the Camera selection drop-down list.
    Because you logged on in Advanced mode, crosshairs are displayed on the LPR camera feed.
  3. Adjust the pan/tilt angles of the camera as needed to align the crosshairs with the target.

Results

The camera is aligned.

After you finish

Repeat the procedure for your other cameras, as needed.