Attaching the SharpX pan/tilt/roll bracket to the hardmount - SharpX X1S, X2S, X1S-CN, X2S-CN, XSU

AutoVu Hardware Guide for SharpX Mobile Installation

Applies to
SharpX X1S, X2S, X1S-CN, X2S-CN, XSU
Last updated
2018-10-05
Content type
Guides
Guides > Installation guides
Language
English (United States)
Product
SharpX

After you have attached the Genetec hardmount to your vehicle, you must attach the SharpX camera using the pan/tilt/roll bracket.

Procedure

  1. Assemble the pan/roll bracket hardware using the included documentation.
  2. Attach the pan/roll bracket to the hardmount using four hex-head cap screws, flat washers, and split washers as shown in the documentation included with the hardmount. Set the alignment for the bracket to allow the bracket to pivot from forward to 90 degrees to the side.
    Tip: Don’t over tighten as you will still need to aim the SharpX camera later.

    Mobile SharpX pan/roll

  3. Slide the SharpX camera on to the tilt bracket, with the bracket's open notch to the top. Leave about a 2.5 cm (1 in.) gap between the back of the bracket and the camera.
  4. Attach the camera to the bracket using the phillips pan head screws, serrated washers, and flat washers.
  5. Attach the assembled SharpX camera and tilt bracket to the pan/roll bracket using hex-head cap screws, flat washers, and split washers.

    Mobile SharpX hardmount

Example

Watch this video to learn more. Click the Captions icon (CC) to turn on video captions in one of the available languages. If using Internet Explorer, the video might not display. To fix this, open the Compatibility View Settings and clear Display intranet sites in Compatibility View.