Connecting SharpX systems in a test environment - SharpX X1S, X2S, X1S-CN, X2S-CN, XSU

AutoVu Hardware Guide for SharpX Mobile Installation

Applies to
SharpX X1S, X2S, X1S-CN, X2S-CN, XSU
Last updated
2018-10-05
Content type
Guides
Guides > Installation guides
Language
English (United States)
Product
SharpX

To verify that everything is working properly before installing your SharpX system in the field, you can power up and connect the system in a lab or similar test environment.

What you should know

Cables and a power supply are provided.

The image below depicts a SharpX mobile setup using the Genetec lab cable (part number AU-KLABPWRKIT for Sharp or AU-K-LABPWRKITX for SharpX). For more information on the available lab cables, contact your Genetec Sales Representative.

Procedure

  1. Connect the SharpX cable to the SharpX and connect the power and network cables to the LPR Processing Unit.
  2. Plug the network cable from the LAN1 port of the LPR Processing unit to the computer.
  3. (Optional) Connect the wheel imaging camera's BNC and power to the LPR Processing Unit via the Tire/Aux Imaging Adapter Module.
  4. Connect the 24 VDC power supply to the LPR Processing Unit's power port and supply power.

Results

You are ready to test the SharpX camera. If you have a wheel imaging camera, you can test that too.