Connecting a wheel imaging camera on a SharpX system - SharpX X1S, X2S, X1S-CN, X2S-CN, XSU

AutoVu Hardware Guide for SharpX Mobile Installation

Applies to
SharpX X1S, X2S, X1S-CN, X2S-CN, XSU
Last updated
2018-10-05
Content type
Guides
Guides > Installation guides
Language
English (United States)
Product
SharpX

To check whether a parked vehicle has moved through the use of digital tire chalking, you can connect a wheel imaging camera to the LPR Processing Unit via the Tire/Aux Imaging Adapter Module.

Procedure

  1. The camera cable extension divides the cable into a separate camera cable and power cable. Terminate the power cable with the 2-pin connector that is included with the Tire/Aux Imaging Adapter Module.
    NOTE: If you are adding wheel imaging cameras to an older LPR Processing Unit (X1, X2), connect the camera cable to the AUX VID 1/2 ports, and power the wheel imaging cameras using the AUX PWR OUT 12V 0.5A MAX port.
  2. Attach the Tire/Aux Imaging Adapter Module to camera ports 2 and 4 of the LPR Processing Unit and tighten the four screws to secure the module.
  3. Connect the BNC from the wheel imaging camera to the port with corresponding SharpX camera.
    NOTE: As indicated on the adapter module, the wheel imaging camera on port 2 will be associated with the on port 1, and the wheel imaging camera on port 4 will be associated with the on port 3.

Example

Watch this video to learn more. Click the Captions icon (CC) to turn on video captions in one of the available languages. If using Internet Explorer, the video might not display. To fix this, open the Compatibility View Settings and clear Display intranet sites in Compatibility View.