Mounting a wheel imaging camera - SharpX X1S, X2S, X1S-CN, X2S-CN, XSU

AutoVu Hardware Guide for SharpX Mobile Installation

Applies to
SharpX X1S, X2S, X1S-CN, X2S-CN, XSU
Last updated
2018-10-05
Content type
Guides
Guides > Installation guides
Language
English (United States)
Product
SharpX

After you have drilled the mounting holes and run the wheel imaging camera cable, you can mount the wheel imaging camera using the supplied hardware.

Procedure

  1. Insert the two M4 x 25 mm bolts through the camera base and vehicle body panel/trunk lid.
  2. Attach the nuts using a 7 mm socket or key wrench and secure the camera base to the vehicle.
    NOTE: (Side mount) Depending on the vehicle, you may need to access the inside of the body panel either through the tail light assembly or by removing the trunk liner.
    NOTE: If it is impossible to access the inside of the body panel, consider using rivet nuts (not provided).

    Tire camera - exploded view

  3. Attach the camera housing to the camera base and secure the housing by tightening the set screws with the provided Allen wrench.
    NOTE: You will have to loosen the set screws later to align the camera.
  4. Replace any tail light assemblies or trunk liners that were removed for the installation.

Example

Watch this video to learn more. Click the Captions icon (CC) to turn on video captions in one of the available languages. If using Internet Explorer, the video might not display. To fix this, open the Compatibility View Settings and clear Display intranet sites in Compatibility View.