Running a wheel imaging camera cable for a SharpX - SharpX X1S, X2S, X1S-CN, X2S-CN, XSU

AutoVu Hardware Guide for SharpX Mobile Installation

Applies to
SharpX X1S, X2S, X1S-CN, X2S-CN, XSU
Last updated
2018-10-05
Content type
Guides
Guides > Installation guides
Language
English (United States)
Product
SharpX

You must run the camera cable to the LPR Processing Unit location.

Before you begin

  • The camera cable extension divides the cable into a separate camera cable and power cable. You must terminate the power cable before running the camera cable.
  • The camera must be assembled with the cable running through the camera base. You will not be able to separate the camera ball from the base after the wire is run.

What you should know

  • The wheel imaging camera is shipped with a 4.5 m (15’) camera cable extension. The cable is IP67 rated and is suitable for all-weather installations.

Procedure

(Side-mount) To run the cable:

  1. Install the provided cable gland (grommet) in the camera cable hole.
  2. Install additional cable glands (not provided) in the hole drilled in the trunk and any other camera cable holes.
  3. Run the camera cable to the LPR Processing Unit location.

(Trunk-mount) To run the cable:

  1. Install the provided cable gland (grommet) in the camera cable hole.
  2. Run the camera cable to the LPR Processing Unit location.
  3. Secure the camera cable to the trunk lid and trunk hinge using tie wraps.

    Securing tire camera cable with tie wraps

Example

Watch this video to learn more. Click the Captions icon (CC) to turn on video captions in one of the available languages. If using Internet Explorer, the video might not display. To fix this, open the Compatibility View Settings and clear Display intranet sites in Compatibility View.