Turning Sharp cameras on and off - Genetec Patroller™ 6.4

AutoVu Patroller Standalone User Guide 6.4

Applies to
Genetec Patroller™ 6.4
Last updated
Content type
Guides > User guides
English (United States)
Genetec Patroller™

If you have more than one Sharp camera installed on your vehicle, you can select which cameras are active.You can turn plate reading on or off for any individual Sharp camera installed on your vehicle. If you have only one camera, you can use the Pause/Resume button in the Genetec Patroller™ main window to turn it on or off.


To turn Sharp cameras on and off:

From the Genetec Patroller™ main window, do one of the following, depending on how Genetec Patroller™ is configured:
  • If you only have cameras installed on the front of the vehicle: tap Left (), Right (), or Both () to turn on the corresponding Sharp camera.

    You’ll know which Sharp is active by the icon displayed. For example, if you see Both (), it means that both cameras are on and reading plates.

  • If you have cameras installed on both the front and rear, or just the rear of the vehicle: tap Cameras.
The Cameras window opens, and you can turn any of them on or off. In the following example, only two cameras are shown (front-right and rear-left).