Configuring wheel-imaging and auxiliary cameras in the SharpOS 13.0 Sharp Portal - SharpZ3 | SharpOS 13.0

AutoVu SharpZ3 Deployment Guide 13.0

Applies to
SharpZ3 | SharpOS 13.0
Last updated
2020-05-19
Content type
Guides
Guides > Deployment guides
Language
English
Product
SharpZ3
Version
13.0

If the SharpZ3 system includes the AUX PoE expansion module, you can connect additional context cameras to the system or you can install wheel-imaging cameras on the patrol vehicle.

Before you begin

Connect wheel-imaging cameras or auxiliary cameras to the PoE expansion module.

What you should know

  • On the Auxiliary cameras page, you can associate up to two wheel-imaging cameras with SharpZ3 cameras. Typically, left and right wheel-imaging cameras are associated with left and right SharpZ3 cameras. However, you can also associate one wheel-imaging camera with more than one SharpZ3 camera.
  • If you are using the Aux PoE module to power third-party hardware, no configuration is required in the Sharp Portal.

Procedure

  1. Log on to the Sharp Portal.
  2. From the Configuration menu, click Cameras > Auxiliary cameras.
    The page lists the SharpZ3 ALPR cameras that are installed on the base unit.
  3. Click the Assigned auxiliary camera field for a SharpZ3 camera and select the auxiliary context camera or wheel-imaging camera that you want to associate with the SharpZ3 camera.
    NOTE:
    • The same wheel-imaging camera can be associated with more than one SharpZ3 camera, typically one per car side.
    • The Assigned auxiliary camera field displays expansion module slot and port, for example, EXP 1 - AUX PoE port 1.
  4. Click Save.

After you finish

Configure wheel imaging settings in Genetec Patroller™. For more information, see the Patroller Administroator Guide.