Connecting the SharpZ3 camera cable - SharpZ3 | SharpOS 13.0

To connect the camera cable to the camera, you must first install the SharpZ3 camera and terminate the camera cable.

1. Remove the plastic protector cap from the camera.
2. Apply a small amount of dielectric compound (included) on the cable connector threads.
   IMPORTANT: Do not let the dielectric compound come in contact with the inside of the cable connector.
   
3. Align the notch on the cable connector with the notch on the camera port.
4. Connect the cable to the camera and tighten the connection is snug, then tighten an additional ¼ turn by hand.
   As you turn the connector ring clockwise, jiggle the connector up and down to make sure that the cable connection is tight enough.
   

   WARNING:

   • Do not overtighten the connector.
   • Only tighten the front of the connector. Tightening the back of the connector will break the camera.