Packing the AutoVu™ Mobility Kit - SharpZ3 13.0 - 13.3

AutoVu™ Mobility Kit - SharpZ3 Hardware Installation Guide

Product
SharpZ3
Content type
Guides > Installation guides
Version
13.3
13.2
13.1
13.0
ft:locale
en-US
Last updated
2021-02-02

The AutoVu™ Mobility Kit must be packed differently depending on the number of SharpZ3 cameras stored in the case.

Procedure

To pack a 2-camera AutoVu™ Mobility Kit, refer to the illustration below, and the steps that follow:

  1. Remove the center divider and store one SharpZ3 camera in each camera compartment.
    NOTE: Camera cables can remain attached to the cameras for storage. Cameras can remain attached to the magnetic mounts.
  2. Pass the camera cables through the notches in the divider.
  3. Coil the camera cables around the outside of the cable storage compartment.
  4. Coil the network and power cables and store them in the center of the cable storage compartment.

To pack a 4-camera AutoVu™ Mobility Kit, refer to the illustration below, and the steps that follow:

  1. Store one SharpZ3 camera in each camera compartment.
    NOTE: Camera cables must be disconnected from the cameras before packing. Cameras can remain attached to the magnetic mounts.
  2. Coil the camera cables around the outside of the cable storage compartment.
  3. Coil the network and power cables and store them in the center of the cable storage compartment.