SharpOS 13.2 Sharp Portal - Recovery page - SharpV | SharpOS 13.2

AutoVu™ SharpV Administrator Guide 13.2

Applies to
SharpV | SharpOS 13.2
Last updated
Content type
Guides > Administrator guides
English (United States)

This section lists the settings found in the Recovery page of the Sharp Portal. Use the Recovery page to import or export settings and to configure a Syslog server.

To navigate to the Recovery page, click Configuration > General settings > Recovery.

The following information is displayed:


Export diagnostics
Export a file that includes SharpV diagnostics and SharpV settings.
Export settings
Exports configuration and diagnostic settings as a .zip file. You can use the .zip file for technical support, or you can import the settings to another Sharp unit for quick configuration
Import settings
Imports configuration settings from a .zip file exported from another Sharp. You can use this .zip file to quickly configure your Sharp. After you import the settings, the Plate Reader service restarts automatically.
IMPORTANT: You can only import settings from a similar Sharp (same model and SharpOS version).
Reset to factory default
Click to reset the SharpV to use the factory default settings. A message confirms the reset and offers to optionally clear the network settings as well. Note that certificates are not cleared in a factory reset.


Use Syslog server
Select this option to configure a central repository for all SharpV log entries.
  • Server
    Enter the IP address or name of the server.
    NOTE: Syslog server configurations do not support IPv6 addresses.
  • Port
    Enter the port number of the syslog server.
  • Network protocol
    Select UDP or TCP.