Terminating and connecting the SharpV input/output cable - SharpV | SharpOS 14.2

You can connect the SharpV camera to an external digital input or external relay using the provided IP67-rated input/output (I/O) cable plug.

What you should know

• To create the connection, you will need wire strippers and a 2 mm flat-head screwdriver.
• In some installation scenarios, the I/O connector is also used to supply 24 V dc to the unit. For more information, see About powering the SharpV G3 using 24 V dc.

1. Disassemble the connector into the three parts.
2. Slide the sealing nut onto the cable.
3. Select the small or large rubber seal depending on the cable diameter and slide the rubber seal onto the cable.

   Seal	Cable diameter
   Small	4 mm to 6 mm
   Large	6 mm to 8 mm

4. Slide the connector housing onto the cable.
5. Remove 30 mm (1.2 in) of cable jacket and 7 mm (0.2 in) of wire jacket.
6. Insert the wires into the coupling nut terminals and tighten the terminal screws using a 2 mm flat-head screwdriver.
   The following pinout diagram corresponds to the SharpV inputs and outputs:

   

   I/O cable assembly pin number	SharpV pinout
   Pin #1	Output 1 +
   Pin #2	Common negative for both outputs
   Pin #3	Output 2 +
   Pin #4	Ground for 24 V power option
   Pin #5	Input 1 +
   Pin #6	Common negative for both inputs
   Pin #7	Input 2 +
   Pin #8	1.55 A Max @ 24 V dc +/-10% for 24 V power option

7. Slide the connector housing onto the coupling nut and tighten by hand.
8. Insert the rubber seal until it is flush with the connector housing.
9. Slide the sealing nut onto the connector housing and tighten by hand.
10. Align the guides on the connector and the SharpV I/O port.
11. Tighten the metal ring by hand.
    IMPORTANT:

    • Do not twist the plastic components. Tighten only the metal ring.
    • Do not use a wrench to tighten the metal ring. Tighten by hand.