SharpOS 13.4 Sharp Portal - Network page - SharpZ3 | SharpOS 13.4

To navigate to the Network page, click Configuration > Network.

IPv4 network settings

Use DHCP

If the patrol vehicle uses a DHCP server, you can configure the SharpZ3 system for DHCP. Consider the following:

• When a SharpZ3 system is configured to use DHCP, the setting applies to the ALPR module, but does not apply to expansion modules. Expansion modules connected to the base unit always use static IP addresses that are defined on the Network page. For the expansion modules to work with the DHCP system, you must configure a compatible Subnet mask and IP address for each module.
• When a SharpZ3 is configured in DHCP and the DHCP server cannot be reached, the default fall-back IPv4 address is 192.168.10.100. On a four-camera ALPR module, the second group of two cameras has a default fall-back address of 192.168.10.100.
  NOTE: The default fallback takes at least two minutes to become effective when no DHCP server is detected at bootup.

Use static IP address

If the SharpZ3 must use addresses withing a specific range, you can configure static addresses for the modules.

IMPORTANT: When assigning specific IP addresses, ensure the configuration stays compatible with the rest of the system, otherwise the base unit, expansion modules, or aux cameras might be unreachable. For example, it is important that all components be on the same subnet.

IMPORTANT: You must use a fixed IP address if you want to stream video to the Security Center Archiver role. You can do this using a static IP address or a reserved IP address on the DHCP server.

IP address

Enter the new IP address you want to assign to the ALPR module. The default is 192.168.10.1 (port 1 and 2) and 192.168.10.2 (port 3 and 4).

Subnet mask

Enter the new Subnet mask for the ALPR module, if applicable. The default is 255.255.255.0.

IMPORTANT: When assigning specific IP addresses, ensure the configuration stays compatible with the rest of the system, otherwise the base unit, expansion modules, or aux cameras might be unreachable. For example, it is important that all components be on the same subnet.

Gateway

Enter the new Gateway for the ALPR module, if applicable. The default is 10.0.0.0.

DNS

Enter the new DNS for the ALPR module, if applicable. The default is 10.0.0.0.

EXP module settings

IP address

Enter the new IP address you want to assign to the expansion module. The default IP address depends on which expansion slot the module is installed in.

Subnet mask

Enter the new Subnet mask for the expansion module, if applicable. The default is 255.255.255.0.