This section lists the settings found in the Position and orientation page of the Sharp Portal. Use the Position and orientation page to define SharpZ3 camera positions on the patrol vehicle roof.
To navigate to the Position and orientation page, click .
The following information is displayed:
- Enable
- When enabled, the system estimates the GNSS position of the license plate of the target vehicle.
Position
- Left/right
- Define how far the camera is installed to the left (0 cm to -400 cmto) or to the right (0 cm to 400 cm) of the GNSS antenna.
- Rear/front
- Define how far the camera is installed the rear (0 cm to -1000 cmto) or to the front (0 cm to 1000 cm) of the GNSS antenna.
- Below/above
- Define how far the camera is installed below (0 -400 cm) or above (0 cm to 400 cm) the GNSS antenna.
Orientation
- Pan
- Define how far the camera is panned to the left (-90°) or to the right (90°) from a straight forward view (0°).
- Tilt
- Define how far the camera is tilted to the up (45°) or down (-45°) from a level installation (0°).
- Roll
- Define how far the camera is rolled counter-clockwise (-45°) or clockwise (45°) from a level installation (0°).