Troubleshooting: Restoring the SharpZ3 PoE camera password - SharpZ3 | SharpOS 13.7

If you lose the password to a PoE camera being used in a SharpZ3 system as a wheel imaging camera or AutoVu™ auxiliary PoE camera, you can restore the camera to its factory configuration.

1. Supply power to the camera.
2. Using the T15 Torx key wrench that is included with the aux tire camera, loosen the three screws and remove the dome.
3. Press and hold the Default button for 6 seconds.
   The green LED flashes randomly for about 90 seconds. When even flashing resumes, it indicates that the camera’s settings and password are restored to their factory default (Username: admin and Password: 1234).
   NOTE: Do not log on to the Sharp Portal yet.
   
4. Reboot the SharpZ3 base unit.
5. Log on to the Sharp Portal.
6. From the Configuration menu, click Cameras > Auxiliary cameras.
7. Click Change camera password and modify the password from the default Username: admin and Password: 1234.
   
8. Store your password safely for future use.