AutoVu™ car camera switch wiring - SharpZ3 | SharpOS 13.1

AutoVu™ SharpZ3 Deployment Guide 13.1

Applies to
SharpZ3 | SharpOS 13.1
Last updated
2020-07-14
Content type
Guides
Guides > Deployment guides
Language
English (United States)
Product
SharpZ3
Version
13.1

To control SharpZ3 camera selection using the AutoVu™ car camera switch, you must connect the switch to the inputs of the base unit.

Important information

  • The blue and pink wires of the cable are not used in a car camera switch installation. Trim these wires so that they do not interfere with the installation.
  • Two 24 AWG jumper wires (shown in black) are required, but are not provided with the kit.

Connect the wires to the base unit as shown in the following wiring diagram: