None - SharpZ3 | SharpOS 13.1

AutoVu™ SharpZ3 Deployment Guide 13.1

Applies to
SharpZ3 | SharpOS 13.1
Last updated
2020-07-14
Content type
Guides
Guides > Deployment guides
Language
English (United States)
Product
SharpZ3
Version
13.1

To ensure a watertight installation, you must seal all cable holes drilled in the body of the vehicle.

What you should know

  • The following steps are not required if you are using cable glands to seal the cable holes.
  • If you run more than one cable through a cable hole, seal the hole using a rubber grommet and butyl tape, not a cable gland.

Procedure

  1. Install a rubber grommet in the cable hole to prevent damage to wires that pass through the vehicle body.
  2. Clean the area around the cable hole using isopropyl alcohol or rubbing alcohol.
  3. When the area is dry, use about a 8 cm (3 in.) section of butyl tape to wrap the cable and the area around the base of the cable gland.
  4. Press the butyl tape into place to ensure a tight seal.