After the table mount is attached to the tilt-pivot head, you can attach the ToughPad dock and keyboard tray to the tablet mount.
What you should know
- ToughPad dock: AS7.P001.100 (Genetec part number: AU-H-PANADKSTG1)
- Keyboard tray: AS7.C100.002 (Genetec part number: AU-H-PANAKEYTRAY)
- 4 x ⅜" flat head screws
Procedure
-
Connect the mounting bracket (A) to the tablet mount (B) as shown using the screws that are pre-fastened to the tablet mount.
-
On the back of the ToughPad dock, set the EXT/INT ANT switch (C) to INT.
IMPORTANT: Do not use the EXT setting. Doing so disables the system's networking capability and the system does not function.
-
Attach the ToughPad dock (D) to the mounting bracket (E) as shown using the screws that are pre-fastened to the mounting bracket.
-
Attach the keyboard tray (F) to the tablet mount as shown using the four ⅜" flat-head screws (G) that are shipped with the keyboard tray.
