Installing SharpZ3 expansion modules - SharpZ3 | SharpOS 13.4

AutoVu™ SharpZ3 Deployment Guide 13.4
Applies to
SharpZ3 | SharpOS 13.4
Last updated
2023-02-03
Content type
Guides > Deployment guides
Language
English
Product
SharpOS
SharpZ3
Version
13.4

The SharpZ3 expansion modules add additional capabilities to the SharpZ3 system. You can install up to three expansion modules in the SharpZ3 base unit.

Before you begin

To complete these steps, you need the following:
  • Phillips #1 screwdriver

What you should know

  • The base unit has three expansion slots. Each slot is covered by an expansion slot protector until a module is installed.
  • It is easier to install the expansion modules before the base unit is mounted in the patrol vehicle.

Procedure

  1. Remove the protector from an available expansion module slot:
    1. Remove the two Phillips screws.
    2. Slide out the protector.
  2. Install the expansion module:
    1. Slide the module into the slot.
    2. Firmly press the module to ensure that the connection at the back of the module is solid.
    3. Secure the module in the slot using the two screws that you removed from the slot protector.
      Tip: While tightening the screws, gently lift up the module. This aligns the tops of the modules and provides slightly more space under the base unit.

Example

Watch this video to learn more. Click the Captions icon (CC) to turn on video captions in one of the available languages.

Browse