Logging on to the SharpOS 13.4 Sharp Portal - SharpZ3 | SharpOS 13.4

To configure SharpZ3 cameras, you must log on to the Sharp Portal.

1. Open your Web browser, and go to https://<SharpZ3 name or IP address>.
   A two-camera ALPR module is configured through one Sharp Portal; a four-camera ALPR module is configured through two Sharp Portals.

   Sharp Portal 1 (camera ports 1 and 2)

   http://192.168.10.1/

   Sharp Portal 2 (camera ports 3 and 4)

   http://192.168.10.2/

   
2. Enter the Username and Password.
   • If you have already logged on and changed the default password, enter your Username and Password and click Connect.
   • If this is the first time you are logging on to the Sharp Portal for this unit, enter the default credentials

     Username

     admin

     Password

     Genetec

3. Click Connect.
   
4. Select the power line frequency that corresponds to the installation location.
   

   60 Hz

   Generally used in North America and South America

   50 Hz

   Generally used in Africa, Australia, Asia, and Europe

   NOTE: For more information on the power line frequency used in your installation location, click here.
5. Click Enter context name and select which regional context to use.
   NOTE: You can change the regional context when you configure analytics for the SharpZ3.
   
6. Click Next.
7. Enter and confirm a new password.
   
   NOTE: You cannot modify the username.
8. Click Next.
9. You are redirected to the logon page. Enter the Username and new Password, then click Connect.
10. Click Connect.