Attaching the ToughPad dock and keyboard tray to the tablet mount - SharpZ3 | SharpOS 13.7

AutoVu™ SharpZ3 Installation Guide 13.7
Product
SharpZ3
Content type
Guides > Installation guides
Version
13.7
ft:locale
en-US
Last updated
2024-09-27

After the table mount is attached to the tilt-pivot head, you can attach the ToughPad dock and keyboard tray to the tablet mount.

What you should know

Use these steps to install the following hardware:
  • ToughPad dock: AS7.P001.100 (Genetec part number: AU-H-PANADKSTG1)
  • Keyboard tray: AS7.C100.002 (Genetec part number: AU-H-PANAKEYTRAY)
  • 4 x ⅜" flat head screws

Procedure

  1. Connect the mounting bracket (A) to the tablet mount (B) as shown using the screws that are pre-fastened to the tablet mount.
  2. On the back of the ToughPad dock, set the EXT/INT ANT switch (C) to INT.
    IMPORTANT: Do not use the EXT setting. Doing so disables the system's networking capability and the system does not function.
  3. Attach the ToughPad dock (D) to the mounting bracket (E) as shown using the screws that are pre-fastened to the mounting bracket.
  4. Attach the keyboard tray (F) to the tablet mount as shown using the four ⅜" flat-head screws (G) that are shipped with the keyboard tray.