Supported Axis Powered by Genetec controller features - Axis Powered by Genetec controllers support a wide range of access control features that depend on the version of Synergis™ Softwire app that it runs. - Axis Powered by Genetec

Axis Powered by Genetec User Guide for A1210 and A1610

Product
Axis Powered by Genetec
Content type
Compliance documents
Guides > User guides
ft:locale
en-US
Last updated
2025-01-22

Axis Powered by Genetec controllers support a wide range of access control features that depend on the version of Synergis™ Softwire app that it runs.

The latest version of the Synergis Softwire app supports the following Axis Powered by Genetec controller features.
Features Supported
General characteristics  
Communication protocol IP
Encrypted communication Yes (TLS 1.2)
P2P communication Yes1
Secure boot Yes
Unit-wide parameters  
Discovery port (default) UDP 2000
Reader setting (Card or PIN or Card only) Yes
Maximum PIN length in digits2 15
Interlock setting (Single door unlock or Single door open) Yes
Reader communication protocols  
Wiegand Yes
OSDP Yes
OSDP (Secure Channel) Yes
Scalability  
Maximum number of credentials (for autonomous decision making) 250,000
Maximum credential length (in bits) 5123

1 Requires Security Center 5.12.0 or later.

2 For keypad readers outputting PIN in 4-bit Burst Keypad Mode, the controller processes the PIN the moment the maximum length is reached, without requiring the ‘#’ key.

3 Supported card formats include Wiegand Standard 26-bit, Corporate 1000 (35-bit), H10306 (34-bit), H10302 (37-bit), and H10304 (37-bit). Custom card formats can go up to 512 bits.