To synchronize the user configuration done from Bosch Remote Programming Software (RPS) and from Security Center, intrusion panel users must be mapped to Security Center cardholders with the same name.
Configuration and management of the users on the intrusion panel can be done in Config Tool, from the Users page of the intrusion panel.
To synchronize the configured users from the Bosch intrusion panel to Security Center, each user is mapped to a cardholder after you retrieve it.
Synchronized users have the following message displayed in the Push status column: Last push succeeded. User currently has no modifications to push.
Push frequency options
You can configure how often the changes you make in Security Center are pushed to the intrusion panel. You can choose one of the following synchronization strategies in the Configuration section:
- Manual
- Changes made to the user mappings table are synchronized immediately after clicking the Push to panel button.
- Automatic
- This option is selected by default. Changes are pushed to the panel from Security Center as soon as they are made. When this option is selected, you do not need to click the Push to panel button to synchronize the user mappings table with the panel.
- Scheduled
- Changes made to the user mappings table are synchronized daily, at the specified time.
Synchronization is skipped if there are no changes to be pushed to the panel.
If you do not want to wait for the scheduled synchronization to start, you can click the Push to panel button to push the changes to the panel immediately.
- Trigger custom event when the panel reaches maximum user capacity
- Turn this option ON to trigger the Bosch Intrusion: Panel is full. event when the panel reaches maximum user capacity.
Manual synchronization options
The following buttons are found in the User mappings section.- Push to panel
- Click to push all pending changes to the intrusion panel right away.
- Force push to panel
- Click to delete all the users from the intrusion panel, and then push the users
configured in the user mappings table to the panel.You can use this option if you want to remove all the disabled users from the panel without having to manually remove each one from Bosch RPS, as it will delete all users and then push the active users from the mappings table to the panel.NOTE: You can access this option from the overflow menu.
