Preparing to add Bosch intrusion panels to Security Center - Bosch intrusion panel 4.4

Before integrating Bosch intrusion panel in Security Center, you need to perform a series of pre-configuration steps.

1. Read the release notes for any known issues, limitations, supported firmware, and other information about this release.
2. Make sure your system meets the Security Center requirements and Bosch requirements. For more information, see your Bosch documentation.
3. Make sure you have the proper license.
   To use the panels in Security Center, your license must include the correct Number of Intrusion detection units you want to control. For more information about licensing, see Genetec™ Technical Support.
4. Make sure you have the right user privileges.
5. Configure the control panel for IP communication.