For Security Center to communicate with Bosch
GV2, GV3, or GV4 intrusion panels through an IP network, you must configure the panel settings
before you add the unit in Security Center.
Before you begin
Read the Bosch quick start guide and installation guide that applies to your
hardware.
What you should know
If you are enrolling the
Bosch panel in mode 1, the default
port is 7702. In mode 2, the default port is 7700.
Procedure
-
Select one of the supported Ethernet
modules.
-
Enable communication between the Bosch Management Remote Programming Software (RPS)
and the panel, using the B420 or B426 Ethernet module.
For more information about enabling communication between RPS and the panel, see
your Bosch documentation.
-
Configure the panel settings using Bosch RPS, such as the intrusion areas, inputs
(points), outputs (relays), automation mode of operation (1 or 2), and other
behavior.
For more information about configuring the panel settings using Bosch RPS, see
your Bosch documentation.
-
Enable communication between Security Center and the panel, using the B420 or
B426 Ethernet modules.
For more information about enabling the panel to communicate with a server over an
IP network, see your Bosch documentation.