Connecting to the CCURE 9000 system - CCURE Access Control 3.8.0

CCURE 9000 Access Control Plugin Guide 3.8.0
Product
CCURE 9000 Access Control
Content type
Guides > Plugin and extension guides
Version
3.8
Release
3.8.0
Language
English
Last updated
2023-10-10

Before you can monitor and control CCURE 9000 access control entities in Security Center, you must connect the plugin to the CCURE 9000 server.

Before you begin

Create the plugin role.

What you should know

  • Each plugin role can connect to a single CCURE 9000 server.

Procedure

  1. From the Config Tool homepage, open the Plugins task.
  2. In the Plugins task, select the plugin role from the entity browser, and click the Properties tab.
  3. Enter the following connection settings:
    Server
    The host name or IP address of the CCURE 9000 server.
    Port
    The TCP port used by the plugin and proxy service to communicate. The default port is 5645.

    The plugin Properties page with the server and port fields completed.
  4. Click Apply.
  5. If not already done, configure the proxy service to use the same port.

Results

If automatic synchronization is disabled, and this is the first time the plugin connects to the CCURE 9000 server, the plugin role changes from red (disconnected) to yellow (partially connected). It remains yellow until the plugin is synchronized with the CCURE 9000.

After you finish