Configuring and adding OSDP readers in Cloud Link Roadrunner™ 2.0 - Cloud Link Roadrunner™ 2.0

To add OSDP readers to a Cloud Link Roadrunner™ unit, configure the readers in the Cloud Link Roadrunner™ Portal.

1. From the hardware tree, select the OSDP reader you added while creating the OSDP channel and click Edit ().
2. In the Properties dialog box, enter the physical address you want to set for the reader, and configure the Beep on card read and Turn off LED when idle options, as desired.
   
3. Click Save
4. Connect and power up the reader.
   The configured bit rate and physical address are sent to the reader, which comes online after it has accepted them.
5. Disconnect or power down the reader.
6. Repeat steps 1 to 5 for the remaining readers.
7. From the hardware tree, select the OSDP channel and click Edit (), then clear the Programming mode check box that you selected while creating the channel.
8. Add the configured readers:
   1. At the top of the Address column, click Add ().
   2. In the Add hardware dialog box, click Add to add the readers at the addresses you have programmed.
9. Click Save.