The Cloud Link Roadrunner™ Portal is the web-based administration tool used to configure and administer the Cloud Link Roadrunner™ appliance and upgrade its firmware.
You can perform the following tasks through the portal:
- Change the password required to connect to the Cloud Link Roadrunner™ appliance.
- Configure the network settings on the Cloud Link Roadrunner appliance so it works on your system.
- Enroll and configure the interface modules connected to the Cloud Link Roadrunner appliance.
- Configure the access control behavior of the appliance for both online and offline operations.
- Test and diagnose the interface readers, I/O, and module connections of the Cloud Link Roadrunner appliance.
- Configure MIFARE DESFire on OSDP.
- Manage X.509 certificates.
- View and export the Cloud Link Roadrunner appliance's status and configuration.
- Upgrade the Cloud Link Roadrunner appliance's firmware.
- Restart the Cloud Link Roadrunner appliance's hardware or software.
Tasks that must be done in Config Tool
You cannot perform the following tasks through the portal. You have to use Security Center Config Tool instead.- Assign devices (input/output contacts, readers) to doors and zones.
- Configure individual door and zone properties.
- Configure I/O linking.
- Configure Card and PIN readers so both the card and the PIN are required to grant access.
For more information about deploying Synergis™, see the following chapters in the
Security Center Administrator
Guide:
- For configuring doors and Card and PIN readers, see Areas, doors, and elevators in Config Tool.
- For configuring zones and I/O linking, see Zones and intrusion detection in Config Tool.