Before you can configure a
Cloud Link Roadrunner™
unit, you must perform some
pre-configuration steps.
Procedure
-
Read the release notes for any
known issues and other information about the release.
-
Have a computer equipped with a network card, Ethernet cable, and a web
browser.
-
(Optional) Have the IP address assigned by your IT department to the
Cloud Link Roadrunner
unit.
-
Connect the OSDP readers to the unit through the proper communication
channels.
NOTE: If multiple OSDP readers are connected to the same RD port, the readers must be
wired as a daisy-chain and not a star.
The RS-485 channel has a built-in 120 ohm
resistor. We recommend using an end-of-line resistor at the last reader to get
impedance matching and avoid signal reflections.
-
Connect physical devices (REX, door sensors, and so on), or use test switches and
LEDs during the configuration phase.
-
Download the latest
Cloud Link Roadrunner
package from the
Product Download
page
on GTAP.
-
Install and configure Security Center with at least one Access Manager role.