Enrolling a DMP intrusion panel using the Entré connection - DMP intrusion panel 4.2.1

DMP Intrusion Panel Extension Guide 4.2.1

Applies to
DMP intrusion panel 4.2.1
Last updated
Content type
Guides > Plugin and extension guides
English (United States)
DMP intrusion panel

Before you can enroll your DMP intrusion panel using the Entré connection, you must configure Entré in DMP Remote Link.

Before you begin


  1. Use DMP Remote Link to configure the following settings to the Entré connection:
    • Entré connection: Net.
    • Entré Incoming TCP Port: The port used by Security Center to connect to the panel.
    • Entré IP: The IP address of the Intrusion Manager server.
    • Entré Passphrase: Leave blank.
    The Entre tab of the DMP Remote Link window.
    For more information, refer to the DMP user documentation.
  2. From the Config Tool home page, open the Intrusion detection task.
  3. From the entity browser, select the Intrusion Manager role.
  4. Click Intrusion detection unit ().
    The Manual add window opens.
  5. Configure the following settings:
    • IP address: The IP address of the DMP intrusion panel.
    • Port: The port that was set as the Incoming TCP port on the DMP panel.
    • Account number: The account number of the DMP intrusion panel.
    • Remote key: Leave blank.
    NOTE: Leave the Remote key field blank even if there is a remote key configured on the panel.
    The Manual Add window with the Remote Link field left blank.
  6. Click Add and close.


The panel is enrolled.