Preparing to integrate DSC PowerSeries intrusion panels - DSC PowerSeries intrusion panel 4.0

DSC PowerSeries Intrusion Panel Extension Guide 4.0

Applies to
DSC PowerSeries intrusion panel 4.0
Last updated
2019-03-11
Content type
Guides
Guides > Plugin and extension guides
Language
English
Product
DSC PowerSeries intrusion panel
Version
4.0
Category
Guides
Plugin and extension guides

Before integrating DSC PowerSeries intrusion panels in Security Center, you must perform a series of pre-configuration steps.

Procedure

  1. Read the release notes for any known issues, limitations, supported firmware, and other information about this release.
  2. Make sure your system meets Security Center and DSC requirements. For more information, see your DSC documentation.
  3. Make sure you have the proper license.
    To use the panels in Security Center, your license must include the correct Number of Intrusion detection units you want to control. Your license must also include the DSC certificate, which is embedded in GSC-1AP-DSC. For more information about licensing, contact Genetec Inc. Technical Support.
  4. Make sure you have the right user privileges.