Mounting the Genetec Cloudlink 110 appliance - Genetec Cloudlink 110

You can use the mounting holes on the Genetec Cloudlink™ 110 to mount the appliance to a suitable flat surface. Alternatively, you can mount the appliance to a DIN rail using the optional DIN rail mounting bracket.

To install the appliance on a flat surface:

1. Install the appliance using the provided self-drilling screws (#6 x 3/8") or machine screws (#6-32 x 3/8").
   NOTE: If your installation requires any other type or length of fasteners, use #6 (M3.5) screws.
   
   In this example, the provided self-drilling screws are installed using a 6 mm (0.25 in) socket.
   
   IMPORTANT: If you’re mounting the appliance to a surface that isn’t grounded, you must connect a ground wire to one of the mounting screws. For more information, see Genetec Cloudlink 110 connections.

To install the Genetec Cloudlink 110 on a DIN rail:

1. Attach the optional DIN rail bracket to the Genetec Cloudlink 110 using the screws and lock washers included with the kit.
   

   CAUTION:

   Using screws other than the ones provided with the kit might damage the appliance if they are longer.
2. Hook the bottom of the bracket to the DIN rail and rotate to engage the clip.
   Tip: Hook the spring behind the DIN rail.