Running Genetec Cloudlink 110 DIP switch command codes - Genetec Cloudlink 110

Genetec Cloudlink™ 110 includes four code DIP switches on the front of the appliance. They allow you to run command codes, which can apply certain configurations and reset settings.

1. Select a command code to run. For more information, see Genetec Cloudlink 110 DIP switch command codes.
2. Enter the code with the DIP switches on the appliance.
3. Press and hold the command code button for 1 second.
   
   The Information LED () confirms that the code was recognized.

   LED name	LED color	Description
   Information ()	Orange: solid 3 seconds	DIP switch code recognized
   	Red: 3 blinks	DIP switch code not recognized

4. To avoid an accidental configuration change, set the DIP switches to ON ON ON ON.
   NOTE: There is no action associated with this code, making it a safe state when configuration is complete.