Attaching the Genetec Motoscan™ main unit to the mounting bracket - Genetec Motoscan™ 1.0

Genetec Motoscan™ Hardware Installation Guide 1.0

Applies to
Genetec Motoscan™ 1.0
Last updated
2018-04-09
Content type
Guides > Installation guides
Language
English
Product
Genetec Motoscan™
Version
1.0

Before operating the Genetec Motoscan™ system, you must attach the main unit to the mounting bracket on the luggage rack of the scooter.

What you should know

During operation, there is no need to access the internal components of the main unit. To reduce the risk of hardware tampering, use a padlock to lock the lid of the case.

Procedure

  1. Place the main unit on the mounting bracket and slide the unit backwards. The rear pins slide into the sloped notches, and then the front pins drop into the front notches.
  2. Attach the main unit to the mounting bracket using the mounting clips.
  3. Lock the mounting clips using the provided key and verify that the main unit is securely attached to the mounting bracket.
    WARNING: You must always use the key to lock the main unit to the mounting bracket before operating the scooter. Failure to do so might result in the main unit detaching from the mounting bracket during operation.
  4. Connect the main unit cable and turn the cable connector sleeve clockwise until you hear a click.
    The unit is now securely attached to the mounting bracket and is ready to be powered up.