To install a Genetec Motoscan™ system that includes a Genetec Motoscan™ EV battery backup module, install the hardware components on the scooter, and connect them using the following wiring diagram. The EV battery backup battery module is required if turning off the ignition cuts all power from the scooter. This is common with electric scooters.
| Component | Description | |
|---|---|---|
| A | Genetec Motoscan™ main unit | The main unit incorporates a two-camera AutoVu™ SharpX system mounted on a ruggedized case. |
| B | Genetec Motoscan™ controller | The controller features toggle switches for camera selection and LED lights to inform the driver of system status. |
| C | Scooter 12 V power | Genetec Motoscan™ typically draws less than 40 W and is designed to run on the power output of a scooter. |
| D | Genetec Motoscan™ EV battery backup module | The EV battery backup module provides power to safely shut down the Genetec
Motoscan™ system. NOTE: This module is only
required if turning off the ignition cuts all power from the scooter. This is
common with electric scooters.
|
| E | Terminal block | The terminal block allows for easy connection of system components. |
| F | Ignition signal | You must tap the scooter's ignition signal. This must be a circuit that supplies 12 V when the key is switched to the RUN position, and is off when the key is in the OFF position. |