Installing the Genetec Motoscan™ controller - Genetec Motoscan™ 1.0

Genetec Motoscan™ Hardware Installation Guide 1.0

Applies to
Genetec Motoscan™ 1.0
Last updated
2018-04-09
Content type
Guides > Installation guides
Language
English (United States)
Product
Genetec Motoscan™
Version
1.0

You must install the controller so that the scooter operator can comfortably reach the camera selection switches while operating the scooter.

What you should know

The controller must be positioned so that the blue LED is above the camera selection switches. If the LED is below the switches, the camera selection switches will be reversed.

Procedure

  1. Find a suitable installation location on the arm of the left mirror.
    IMPORTANT: The controller must not be installed on the right side. The operator's right hand is dedicated to controlling the accelerator.
  2. Secure the controller mount to the mirror arm using a hex key.
  3. Fish the controller cable through the scooter body to the terminal block location.
  4. Verify that the cable does not interfere with the motion of the scooter's handlebars.
  5. Connect the cable to the back of the controller.