Viewing your Genetec Patroller™ statistics - Genetec Patroller™ 6.6

Genetec Patroller™ Law Enforcement User Guide 6.6

Applies to
Genetec Patroller™ 6.6
Last updated
Content type
Guides > User guides
English (United States)
Genetec Patroller™

If you want to see statistics about such things as the number of total reads or the number of accepted hits, you can check your Genetec Patroller™ statistics from the Status screen.

What you should know

If some of the information does not fit on your screen, you can swipe the window up and down as needed.


To view your Genetec Patroller™ statistics:

In the main Genetec Patroller™ window, tap Status, then tap Statistics.
NOTE: The following screen capture is an example. The information displayed in the window varies depending on the Genetec Patroller™ mode you are running.


The Statistics window provides the following information:
NOTE: The camera information listed is dependent on the cameras that are installed and in use on the vehicle.
Number of manually captured reads.
Front left/right
Number of reads made by the front left/right ALPR camera(s).
Rear left/right
Number of reads made by the rear left/right ALPR camera(s)
Front center/Rear center
Number of reads made by the front or rear center camera(s).
Total reads made.
(MLPI only) Shows the location of the Parking facility that is being patrolled.
(City and University only) Shows the currently selected permit restriction (if applicable).
Overtime rule
(City and University only) Shows the currently selected overtime rule (if applicable).
(City and University only) Shows how many hits received for the permit restrictions and overtime rules.
Number of hits you have accepted.
Number of pending hits that you have not accepted or rejected.
Hits/Reads ratio
The ratio of hits to reads.
Pending upload
(City, University only) Shows how many reads must be uploaded and shared with other patrol vehicles registered with the same Plate link account.