Turning Sharp cameras on and off - Genetec Patroller™ 6.6

Genetec Patroller™ MLPI User Guide 6.6
Product
Genetec Patroller™
Content type
Guides
Guides > User guides
Version
6.6
Language
English
Last updated
2021-02-01

As you drive the patrol vehicle, you can turn the Sharp cameras on and off to detect license plates on specific sides of the patrol vehicle.

What you should know

When patrolling for parking enforcement, you might need to select cameras based on the route you are patrolling. For example for, for on-street parking you could select only the right-side cameras. For patrols in parking lots, you could select cameras on both sides of the vehicle.

Procedure

To turn Sharp cameras on and off in Genetec Patroller™:

  1. From the Genetec Patroller™ main window, do one of the following:
    • If only one camera is installed, use the Pause/Resume button in the Genetec Patroller™ main window to turn it on or off.
    • If one camera is installed on each side, tap Left (), Right (), or Both ().
    • If two cameras are installed on each side, or for other special configurations, tap Cameras () and select which cameras to activate.

To turn Sharp cameras on and off using the AutoVu™ car camera switch:

  1. If the AutoVu™ car camera switch is installed in the vehicle, use the right and left toggle switches to activate or deactivate the associated cameras.
    The AutoVu™ car camera switch also includes LED lights to inform you of the current camera activation (red) and to show system power (blue).