On a patrol vehicle equipped with Sharp ALPR cameras, the Genetec Patroller™ software running on the in-vehicle computer sends license plate reads to the Genetec™ Curb Sense™ back office for processing. As the operator of the patrol vehicle, you must perform certain tasks before, during, and after you patrol a city.
Before you patrol a city
These are the common tasks to perform before you begin your patrol. If you can’t complete the tasks on this checklist, contact your administrator.
| Task | Description | Where to find more information |
|---|---|---|
|
To open the Patroller application, you must log on to Curb Sense. |
|
|
Check the Camera connection status icon ( |
|
|
If the Curb Sense™
icon ( |
|
|
If are already logged on to Curb Sense, and if you are assigned to multiple cities, you must select a city before you begin your patrol. IMPORTANT: For Curb Sense to
process license plate reads, you must select the correct city.
|
) to verify that
the Sharp cameras are online.
) displays a check
mark, you can begin your patrol.During your patrol
As you drive the patrol vehicle along your patrol route, you must ensure that the correct cameras are activated.
| Task | Description | Where to find more information |
|---|---|---|
|
|
), 
), or 
).
) and
select which cameras to activate.After you finish patrolling a city
Depending on how many cities you are assigned to, you can begin a patrol in a new city or log off.
| Task | Description | Where to find more information |
|---|---|---|
|
To begin a new patrol, drive to the new city, tap City
selection ( IMPORTANT: For Curb Sense to
process license plate reads, you must select the correct city.
|
|
|
When you finish your patrols for the day, log off from Curb Sense. |
), and select the new city.