Enabling Bosch intrusion areas to be triggered in Security Center - Genetec™ Intrusion Protocol 5.0.0

Genetec™ Intrusion Protocol Extension Guide 5.0.0
Applies to
Genetec™ Intrusion Protocol 5.0.0
Last updated
2023-08-04
Content type
Guides > Plugin and extension guides
Language
English
Product
Genetec™ Intrusion Protocol
Version
5.0

Intrusion areas on a Bosch intrusion panel can be remotely triggered from Security Center by configuring a virtual output point in RPS and Config Tool. This allows Security Center users and actions to trigger intrusion panel workflows, such as activating horns and sirens, or contacting the authorities.

What you should know

For more information about configuring a Point Source as an Output using Bosch RPS, see your Bosch documentation.

Procedure

  1. In the POINTS section of the Bosch Remote Programming Software (RPS), create a new point and set the Point Source to Output for each point on the panel that you want to use to trigger an alarm.
    POINTS section of the Bosch Remote Programming Software
  2. Configure the profile and area for each point, so they can then be used in Security Center to trigger alarms for the areas that the points are associated with.

Results

You can now use the Trigger intrusion alarm command in the Intrusion detection area widget to trigger an alarm in Security Desk for the configured areas.

After you finish

Assign the outputs to trigger alarms.