Preparing a Satel intrusion panel for enrollment - Genetec™ Intrusion Protocol 5.0.0

Genetec™ Intrusion Protocol Extension Guide 5.0.0

Applies to
Genetec™ Intrusion Protocol 5.0.0
Last updated
2023-08-04
Content type
Guides > Plugin and extension guides
Language
English
Product
Genetec™ Intrusion Protocol
Version
5.0

Before integrating Satel intrusion panels in Security Center, you must perform a series of pre-configuration steps using Satel DloadX.

Before you begin

Procedure

  1. Install and open Satel DloadX.
  2. If the Ethernet settings are not already set in the panel, use a serial cable to connect the DloadX server to the Satel panel.
  3. Establish communication between DloadX and the panel:
    1. From the Connection menu, select Port COM.

    2. After the connection is established, click on the Data menu and select System and hardware structure.

    3. In the structure dialog box, click on the ethernet module.
    4. Enter a static IP address for the panel.

    5. In the Integration section, select the Integration option.

    6. (Optional) Change the port used to communicate with the Satel intrusion panel. By default, this is port 7094.