If you need to ingest ALPR data from on-premisis Macq cameras that support the QCam5
protocol, you must configure a Macq QCam5 API data source. In this integration, the Genetec™ Third-Party ALPR is seen as a Central Macq M3 by the Macq camera.
Before you begin
- Add Macq cameras to your system.
- Ensure you have access to the QCam toolbox for the relevant Macq cameras.
Procedure
-
Enable data source by activating the Enabled check box.
-
Enter a name for the data source.
-
Define a REST port for the data source.
Tip: The default port is 443.
-
In the Web SDK host field, enter the name of the host used for
Security Center authentication.
NOTE: This should be the same IP address as the directory, unless the Security Center configuration was modified and the Web SDK is running on a
different server.
-
In the Web SDK port field, define the port used for Security Center authentication.
Tip: The default port is 443.
-
If your authentication type is local, select the Allow self signed
certificates check box.
-
To learn more about the API used to configure this data source, activate the
Activate API documentation checkbox and click the API
documentation link.
-
Click Apply.