Configuring badging to arm and disarm areas on a Honeywell Galaxy intrusion panel - Honeywell Galaxy intrusion panel 3.1

Honeywell Galaxy Intrusion Panel Extension Guide 3.1

Applies to
Honeywell Galaxy intrusion panel 3.1
Last updated
2022-03-09
Content type
Guides > Plugin and extension guides
Language
English
Product
Honeywell Galaxy intrusion panel
Version
3.1

In Security Center, you can configure an area to be armed and disarmed when a cardholder presents an access key or badge at the reader.

What you should know

You cannot define multiple swipes for arming and disarming on the same reader.

Procedure

  1. From the Config Tool home page, open the Intrusion detection task.
  2. Select the Honeywell Galaxy intrusion panel from the entity browser.
  3. On the Areas tab, select an area from the list.
  4. To configure the arming of select doors by specific cardholders, do the following:
    1. In the Badging section, move the Armed slider to ON.
    2. In the Swipes field under the Armed toggle, enter the number of card swipes required to arm the door.
    3. In the Seconds field, enter amount of time in seconds allowed for the total swipes.
      Entering 2 into the Swipes field, and then 10 into the Seconds field sets the badging requirement to two swipes within 10 seconds.
      The badging requirements for arming an area.
    1. In the Manage cardholders / doors section, expand the Arm section.
    2. Right-click Doors, click Add doors, and then select the door or doors you want to use to arm the area.
    3. Right-click Cardholders, click Add cardholders, and then select one or more cardholders.
  5. To configure the disarming of select doors by specific cardholders, do the following:
    1. In the Badging section, move the Disarmed slider to ON.
    2. In the Swipes field under the Disarmed toggle, enter the number of card swipes required to arm the door.
    3. In the Seconds field, enter amount of time in seconds allowed for the total swipes.
      Entering 2 into the Swipes field, and then 10 into the Seconds field sets the badging requirement to two swipes within 10 seconds.
      The badging requirements for arming an area.
    4. In the Manage cardholders / doors section, expand the Disarm section.
    5. Right-click Doors, click Add doors, and then select the door or doors you want to use to disarm the area, making sure to pick different doors than those used to arm the area.
    6. Right-click Cardholders, click Add cardholders, and then select one or more cardholders.