You can set up events from a panel to trigger actions in Security Center, using event-to-actions.
What you should know
Procedure
- From the Config Tool home page, open the System task.
- Click the General settings view, and click the Actions page.
-
On the Actions page, click
.
- From the When list in the Event-to-action dialog box, select an event.
-
(Optional) Click Specify a condition.
NOTE: Conditions differ based on what you select from the When list.
-
In the From option, select an Intrusion
detection unit or Intrusion detection
area that is the source of the event.
For admin users, the event-to-action occurs by default when Any entity triggers the event you selected. Other users must select a source.
-
From the Action list, select an action, and enter any
additional information required about the action.
If you select the Trigger output action, you must select the output relay to trigger, and its output behavior.
-
In the Effective option, click
Always, and select a schedule when this
event-to-action is active.
If the event occurs outside of the defined schedule, then the action is not triggered. By default, the Always schedule is selected.
- Click Save.