Adding driver containers - Inter-System Gateway 1.0

To use a tracking system, the container image corresponding to the driver of that tracking system must be loaded to a docker engine.

1. Log on to the IS Gateway web portal.
2. On the home page, click the Container () tab.
3. Click the button besides the docker engine label, and then click Add driver container.
4. In the Add driver container window that opens, enter the following information:
   

   Label

   Label used to identify this driver container in the list of containers on the left.

   Driver

   Select the driver you want to install.

   Version

   Select the driver version you want. The latest version is selected by default.

   Port

   Port used to communicate with the driver.

   Network adapter

   Select the network adapter used by the driver to communicate with the IS Gateway service.

   Show advanced

   Some drivers require additional communication ports to be open. If necessary, click here to add those ports.

5. Click Add.
   The IS Gateway immediately downloads the required driver container image from the repository. A notification is shown on the upper right corner of the browser page while this is being done.

   

   After the download completes, the new driver container is displayed in the list of containers on the left, under the selected docker engine.

   

   The possible driver container statuses are:

   Created

   The container is created but was never started.

   Running

   The container is started.

   Exited

   The container is stopped.

   Error

   The container has an error.

   Unknown

   Unknown status. This might happen when you restart the container.

6. Start the driver container.
   Click the button besides the driver container label and click Start. For more information, see Interacting with driver containers.