Switching between original and protected video streams in the Monitoring task - KiwiVision™ 4.6.1 | Security Center 5.10.4.0

KiwiVision™ User Guide for Security Center 5.10.4.0

Applies to
KiwiVision™ 4.6.1 | Security Center 5.10.4.0
Last updated
2022-06-22
Content type
Guides > User guides
Language
English (United States)
Product
KiwiVision
Version
4.6

When privacy protection is enabled on your cameras, you can switch between viewing the original video streams and the protected video streams in the Monitoring task.

What you should know

  • You must be granted the Remove privacy protection privilege. Only users with this privilege are able to view the original video streams.
  • You can either remove privacy protection from video in a single monitoring tile or from all monitoring tiles at the same time.

Procedure

To switch between the original and protected video streams of a specific camera in a tile:

  1. From the Security Desk home page, open the Monitoring task.
  2. To view the original stream, right-click the tile displaying the protected stream, and click Camera > Remove privacy protection.
  3. To view the protected stream, right-click the tile again, and click Camera > Reinstate privacy protection.

To switch between the original and protected video streams of all cameras in tiles:

  1. From the Security Desk home page, open the Monitoring task.
  2. To view the original streams, at the bottom of the task, click Show original streams.
    NOTE: When Show original streams is enabled, all cameras subsequently displayed in the same Monitoring task show the original stream by default.
  3. To view the protected streams, at the bottom of the task, click Show protected streams.
  4. (Optional) Configure event-to-actions to trigger the Show original streams for all tiles and Show protected streams actions automatically.