Adding video analytics scenarios to cameras - KiwiVision 4.8.0 | Security Center 5.12.0.0

Before you can monitor KiwiVision™ video analytics in Security Desk, you must apply video analytics scenarios to your cameras.

1. From the Config Tool homepage, open the Video task.
2. From the area view, select a camera onto which you want to apply the analytics scenario.
3. Select a category of analytics:
   • Click Video analytics > Security monitoring.
   • Click Video analytics > People counting.
   
4. Choose an analytics scenario:
   • Click the type of analytics scenario you want to add.
   • Add an analytics scenario by importing an existing configuration.
5. (Optional) Switch Advanced mode to ON to display additional settings.
   NOTE: Advanced mode is only available for intrusion detection and object detection scenarios. When Advanced mode is disabled, the advanced settings you configured are hidden, but remain active.
6. From the Stream menu, select the stream that you want the analytics to be applied to:
   • Live
   • Remote
   • High resolution
   • Low resolution
   • Recording

   Tip: If your camera uses HD or Full HD for the Live or Recording streams, consider using a different stream for analytics to minimize the load on the KiwiVision™ video analytics modules.

   Higher resolution streams require significantly more resources. In most cases, VGA resolution is sufficient for video analytics deployments. VGA resolution is always recommended unless there is a specific reason to use a higher resolution.

7. Click Apply.