To grant cardholders access at doors using a MorphoManager biometric device, you must
associate the biometric information of a cardholder with their Security Center credential.
What you should know
A cardholder's user ID in MorphoManager does not match their credential in Security Center. If you need to search for a
cardholder, you must do so using a different field.
Procedure
-
In the Cardholder management task in Config Tool or Security Desk, select the cardholder to
configure, and then click Modify ().
-
In the cardholder configuration dialog box, click Morpho configuration ().
If the cardholder has not been created yet, an error message appears.
-
Select the Wiegand credential that you want to associate the biometric to, and
click Configure biometric.
-
In the MorphoManager enrollment client, select the user policy that you
created, then add a user photo and set up the biometric configuration
for the cardholder.
For information about using the MorphoManager enrollment client, see the
MorphoManager documentation.
After successfully enrolling the cardholder with the MorphoManager
biometric device, the message Configured appears in the
Status section of the credential.
-
Click .
Results
The cardholder and their credential information is synchronized in the MorphoManager
system. The cardholder can now access the door, using the biometric device that was
configured and according to the access rules that are defined for the cardholder.
Depending on the authentication type that was configured in , the cardholder might also have to present their card credential at the
door before presenting their biometric information.
If you assign a different
credential to the cardholder, you must associate the biometric configuration with the new credential.
If you assign a temporary card to the cardholder, the biometric configuration is
automatically re-mapped to the temporary card until the original credential is
returned.