After the tele-pole is assembled, you can attach the tilt-pivot head and upper swing arm.
What you should know
Use these steps to install the following hardware:
- Tilt-pivot head
- RAM-VB-TNT90-1 (Genetec part number: AU-H-RAMTNT90)
- Swing arm
- RAM-VB-109-3U (Genetec part number: AU-H-RAMSWING)
Refer to the following diagram when assembling the tilt-pivot head:
- A
- Nylon washer
- B
- Lock nut
- C
- Flat washer
- D
- Carriage bolt
- E
- Tilt-pivot head assembly
- F
- Swing arm
- G
- Plastic knob
- H
- Thrust washer assembly:
- 2 x flat washers
- Ball bearing washers
- I
- 1 1/4" flat washer
- J
- Nylon washer
- K
- Hex bolt
Procedure
-
Rotate the tilt-pivot assembly (E) enough to place the carriage bolt (D) through the square opening from the bottom.
-
Slide the nylon washer (A) onto the carriage bolt with the flat side of the washer touching the tilt-pivot assembly.
-
Place the swing arm (F) over the carriage bolt and attach it using the flat washer (C) and lock nut (B).
NOTE: The manufacturer's name "RAM" must be facing downward. When you invert the finished assembly, "RAM" will be facing upward.
The assembled tilt-pivot head should look like this:
Connect the tilt-pivot head to the tele-pole:
Refer to the following diagram when mounting the tilt-pivot head onto the tele-pole:
-
Sandwich the nylon washer (J) between the upper swing arm (F) and the lower swing arm (L).
-
Insert the hex bolt (K) downward, connecting the upper and lower swing arms.
-
Slide the 1 1/4" flat washer (I) onto the hex bolt.
-
Create a thrust washer assembly (H) using a ball bearing washer between two flat washers and slide the assembly onto the hex bolt.
-
Screw the plastic knob (G) onto the hex bolt to secure the swing arm assembly.